Waysmall setup

From GumstixDocsWiki

Setup and power up

1) Connect the serial cable(s) and USB cable into the waysmall computer and then into the serial or USB ports on the host computer on which programming will be setup.

Note that the USB client port on this waysmall computer CANNOT be used to connect a usb camera, drive or other usb device.

2) If using bluetooth, insert the rubber duck antenna into the antenna connector. You may need to cut a hole in the plastic waysmall case in order to insert the antenna through the case.

3) If using an MMC card, plug the MMC card into the MMC slot in the waysmall computer.

4) Insert a wall adapter into the power slot to power up the waysmall computer.

Setting Up Communications

Once the waysmall computer is setup, go here.